1977 BMW 630csi: H&B


ugh this was a nightmare, was a huge amount of rust in the pass well. think it was from the harness grommet over the glovebox being nonexistent. i discovered it late in the build while doing the new driveshaft. i noticed a bubble in the undercoating then poked with a flat head, that flathead went all way thru. the carnage is below.


the best thing i could do was cut it out. cut all the rust from the belly on both pass. side foot wells. added new flat stock and welded her up, slapped on some POR-15 marine clean, metal ready, and paint. finished up the underside with some new undercoating.




Comments are closed.